USING YOUR ICE MACHINE
Icemaker operation
Make certain water pressure is at least 20 psi and no •
more than 120 psi and the water is turned on.
The unit must be installed level for proper ice maker •
operation.
The shutoff arm wire must be down in its lowest position •
for the ice maker to operate.
When the freezer section and ice maker unit has suf-•
ficiently cooled, the ice maker will harvest ice cubes
automatically.
When the ice bucket is full, the ice maker will automati-•
cally shut off.
You may manually stop the ice maker by raising the •
shut off arm to the locking position at the up most posi-
tion.
Arm down, ice maker
will operate
Arm up, stops operation
When operation of the appliance is to be discontinued for
any length of time, the ice cube cavity in the ice maker
should be emptied and dried. The water supply and power
supply should also be shut off and the ice bucket should be
emptied and cleaned.
If the ice is not used regularly, it will clump together with
time. For best ice results, discard ice in the bin as required
and allow the ice maker to make a new fresh batch of ice.
5
Figure 6
Cover
pulls off
Water adjustment screw behind cover
on side of housing
Turning on the ice machine
After connecting the water supply, and setting your ice ma-
chine in place plug the power cord into the wall receptacle.
Then place the switch located in the grille (see Figure 5) to
the “ON” position. The temperature control is factory pre-
set, allow the ice maker to run for 24 hours so the interior
temperature will stabilize. If you wish to adjust the interior
temperature use a small bladed screwdriver pushed through
the right hand side of the grille to turn the temperature
control shaft. Turning it clockwise will make the unit colder.
Turning it counterclockwise will make it warmer. Turning it
counterclockwise until it stops will shut off the compressor
and fan motor.
Figure 5
“ON/OFF” Rocker
Switch in front grille
Temperature control lo-
cated behind right side of
air intake -exhaust grille.
Should you turn off your control, allow at least five (5) min-
utes before restarting in order to give the motor control time
to automatically reset so that it can restart the motor. Electri-
cal power to your unit is controlled by the “ON/OFF” rocker
switch located in the front grille. (See Figure 5).
(40 páginas)
(2 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais